润滑油基础油的生产工艺及发展趋势

本文主要分析"老三套"生产工艺、异构脱蜡和加氢生产工艺,并探讨我国润滑油基础油生产工艺的发展方向。     

海面油膜的偏振反射特性仿真实验

为了给海面溢油污染识别检测提供理论基础,根据菲涅尔反射公式的偏振反射系数,结合偏振双向反射率因子和粗糙海面的概率密度分布函数,建立了完善的pBRDF模型,仿真在不同太阳入射角度、不同探测器观测角度以及不同海面风速风向等条件下海水和油膜的偏振反射分布函数。结果表明:海水和油膜太阳天顶角为53°和56°时P偏振反射率分别为1.0×10^-5和2.5×10^-5,S偏振反射率随着太阳天顶角的增加而增加;海面风速越大偏振反射率峰值越小;海面风向只改变pBRDF的空间位置;海水和油膜线偏振度空间分布有明显差异。搭建实验平台相机以40°拍摄时,得出海水和油膜的线偏振度分别在0.2~0.4, 0.5~0.7之间,同时表明利用偏振探测获取目标场景的偏振度和偏振角图可提高图像质量。     

中压加氢裂化生产合格喷气燃料技术开发与应用

为满足市场对喷气燃料的需求并与企业现有装置相契合，中国石化石油化工科学研究院（简称石科院）开发了生产合格喷气燃料的中压加氢裂化技术。通过考察反应压力、裂化催化剂、原料油、转化深度及体积空速对喷气燃料性质的影响规律，提出了中压条件生产合格喷气燃料的加氢裂化技术方案。中压加氢裂化生产合格喷气燃料技术在中国石化上海石油化工股份有限公司1.5 Mt/a中压加氢裂化装置得到工业应用，在国内首次实现了中压条件下蜡油生产合格喷气燃料。装置工业标定结果表明，采用该技术加工高硫减压蜡油（VGO）馏分，在氢分压约10 MPa的条件下，喷气燃料馏分收率达到20%以上，且满足3号喷气燃料质量要求，尾油馏分BMCI值约为10，是优质的裂解制乙烯原料。     

悬浮于润滑油中的颗粒运动分析及其对油膜压力的影响

对含有固体颗粒的局部润滑流域建立格子Boltzmann(LBM)离散模型,分析固体颗粒在润滑油中的动力学特性;考虑颗粒形状的影响,推导计入单个固体颗粒运动的润滑方程,并分析得到油膜压力;将油膜流动特性与颗粒动力学计算相结合,分析不同形状的颗粒运动对于油膜压力的影响。分析发现,当颗粒进入润滑油后,经过很短的瞬时颗粒就会达到一个瞬态稳定的状态,无论颗粒在油膜厚度方向的初始位置位于两壁面之间的中线上侧还是下侧,颗粒都会向中线位置移动;当颗粒速度为0时对于油膜压力的影响较大,随着颗粒速度逐渐增大,颗粒对于油膜压力的影响逐渐减小;当颗粒的宽度在油膜厚度方向相同时,长宽比越大的颗粒对于油膜压力的影响也越大;当颗粒长轴相等时,颗粒在油膜厚度方向的宽度越大,则其对于油膜压力的影响也越大,即颗粒形状对于油膜流动的阻碍能力越强,则其对于油膜压力的影响越大。     

高温泵轴承失效分析及润滑可靠性监测系统的应用

某重油催化装置油浆泵采用集中油雾润滑方式,油液监测发现轴承润滑油中的金属元素含量高,并且呈急剧增加的趋势,拆机检查发现油浆泵轴承出现了严重磨损。分析该油浆泵轴承磨损原因,提出了采用稀油润滑和油雾润滑组合方式来改善轴承润滑。同时,采用了大型炼化企业机泵群油液监测平台对关键动设备进行状态监测,有效保证了设备长周期安全运行。     

Novel insights on the impact of top water on Steam‐Assisted Gravity Drainage in a point bar reservoir

As efforts are made to efficiently exploit and recover bitumen resources in Canada, increasingly more complex reservoirs in the Athabasca area continue to challenge the application of Steam‐Assisted Gravity Drainage (SAGD) technology. Several studies have been done to investigate the impact of heterogeneities/complexities such as shale barriers, lean zones, and top and bottom water on the performance of the SAGD process. However, the literature is deficient for point bar deposits with top water zones, a common occurrence in oil sands systems. This study, by using thermal reservoir simulation, examines SAGD performance in a point bar deposit reservoir where an overlying top water and an inclined heterolithic strata (IHS) is present. The results show that where the top water is unconfined and steam injection pressure is higher than that of the top water zone, there is a loss of thermal energy, but the top water does not impact steam chamber development. At steam injection pressure lower than that of the top water zone, top water continuously drains into the reservoir and constrains the size of the chamber. However, the IHS zone helps to delay drainage of the top water into the chamber when steam is injected at underbalanced conditions. Finally, under proper steam injection pressure conditions, top water production can be considerably delayed.     

Effect of Different Cosolvents on Transesterification of Waste Cooking Oil in a Microreactor

Biodiesel was prepared from waste cooking oil combined with methanol. The process was performed via transesterification in a microreactor using kettle limescale as a heterogeneous catalyst and various cosolvents under different conditions. n‐Hexane and tetrahydrofuran were selected as cosolvents to investigate fatty acid methyl esters (FAMEs). To optimize the reaction conditions, the main parameters affecting FAME% including reaction temperature, catalyst concentration, oil‐to‐methanol volumetric ratio, and cosolvent‐to‐methanol volumetric ratio were studied via response surface methodology. Under optimal reaction conditions and in the presence of the cosolvents n‐hexane and tetrahydrofuran, high FAME purities were achieved. Considering the experimental results, the limescale catalyst is a unique material, and the cosolvent method can reduce significantly the reaction time and biodiesel production cost.     

柱塞副微观表面对间隙油膜压力的影响

根据分形理论中的W-M函数建立柱塞与缸体孔表面三维形貌数学模型,并利用MATLAB软件编写程序,分析分形维数对表面微观形貌的影响。将柱塞副间隙油膜沿轴向展成平面,建立油膜厚度及压力分布计算模型,采用有限体积法求解二维雷诺方程,分析粗糙度对柱塞副间隙油膜压力分布的影响。结果表明:随着分形维数的增加,柱塞表面粗糙度呈增加趋势,且表面粗糙度越大,压力峰值越大。     

Use of Beta Cyclodextrin to Remove Cholesterol and Increase Astaxanthin Content in Shrimp Oil

Shrimp oil is extracted from shrimp (Litopenaeus vannamei) cephalothorax and subjected to the removal of cholesterol by β‐cyclodextrin (βCD). Different oil/βCD ratios (1:2, 1:3, and 1:4, w/w) and homogenization times (1, 10, and 20 min) are used. Cholesterol deduction is attained with increasing βCD levels and homogenization time. Astaxanthin content is augmented, while cholesterol concentration is reduced. Nevertheless, oil yield and astaxanthin concentration of treated oil are decreased as βCD levels are increased. To increase the oil yield, the used βCD is further extracted for three times with ethyl acetate at 1:10 (w/v) ratio, in which yield is increased from 44.6% to 64%. Cholesterol removal of 95% is obtained, while astaxanthin content is increased. Lipid oxidation is lowered as indicated by the lower TOTOX value, peroxide value, thiobarbituric acid reactive substances, and p‐anisidine value. However, lipid hydrolysis is slightly increased after treatment. Volatiles, especially aldehydes and alcohols, are decreased after treatment. FTIR spectra confirm the removal of phospholipid, which might be associated with the decreased oil yield after treatment. With the developed process, total fatty acid is increased by 15.6%, in which monounsaturated fatty acid (MUFA) and polyunsaturated fatty acid (PUFA) are augmented. βCD could remove cholesterol, increase astaxanthin and fatty acid content. Practical Applications: Shrimp oil has been known to be a rich source of astaxanthin and PUFAs with health benefit. However, it also contains cholesterol, which can be a drawback for consumption as the supplement. The removal of cholesterol, while maintaining PUFA and astaxanthin could pave a way for promoting the intake of shrimp oil. Use of βCD for oil treatment with subsequent extraction of remaining oil in the used βCD could be implemented with ease. Another advantage of the developed process is to increase both fatty acid and astaxanthin contents in the resulting oil. As a consequence, shrimp oil with lowered cholesterol can be directly used as food ingredient and also for neutraceutical purpose.     

浮法玻璃熔窑火焰空间石油焦部分替代重油燃烧的数值模拟

针对浮法玻璃熔窑火焰空间建立模型并进行了数值模拟，在保证热值相同的前提下，对比研究了重油燃烧及将石油焦部分替代重油燃烧时的流场分布特征。结果表明，石油焦部分代替重油燃烧后，两种燃料可很好地混合燃烧，窑炉内温度制度基本不受影响；石油焦着火时间比重油长，两种燃料混合燃烧时平均着火点滞后于仅使用重油时，且燃烧路径更长，燃烧时产生了大量CO，整个火焰空间及烟气出口处NOx的平均排放量与仅使用重油相比降低了30.02%，NOx减排效果明显。